Vehicles
16 not categorized PORSCHE 993 LOWER ARM CONTROLCan't find what you need? Try browsing the Accessories or Exploded Diagrams!BBI9964010004 Features
$795.00
Make a selection 115970AAR01 Panamera models with optional air suspension utilize four sensors to control the ride height. This is accomplished via the use of a small linkage or link which connects the sensor to the suspension. As the car is raised or lowered, the link moves the sensor up or down sending a signal to the computer telling it how high the car is. When you replace the non-adjustable factory link with this adjustable design, the output of the sensor makes the computer believe that the car is higher than it is. So, the computer will lower the ride height. The simplicity of this setup is that it retains full functionality of the factory system. Be warned, all adjustable lowering links are not the same! These links are machined al...(choose a part on the right to read more) General FitmentPANAMERA 2010-14
From $324.50
Make a selection BBI9865010001 Features
$845.00
Make a selection FVD34791100 Lowering your car without a bump steer kit effectively pulls the steering out of alignment and requires constant steering adjustments that make the car difficult to control. This adjustable bump steer kit will fully compensate to return the steering rack / geometry back to pre-lowered specifications. Our bump steer kit is manufactured to the highest of German standards to ensure the quality, performance and reliability you expect from your Porsche. Features: alloy steel, sealed spherical rod end 14 mm tapered wedge for secure fitment inside the steering arm made for lowering below 30 mm (1.18 inches) / raised spindles allows tie rods to be adjusted downwards no binding throughout suspension travel range finishe...(choose a part on the right to read more) General Fitment911 1970-73
From $284.90
Make a selection FVD34391101SET Replace worn-out original front lower control arm bushings to return your car to its intended suspension geometry and steering feedback. Features: better handling reduces that sloppy steering feel does not produce any noise like the teflon bushings. Rubber has the original shore hardness value of 65 (like oem) fit's like oem, simple installation made in Germany if you are looking for a sportier upgrade we suggest our sport lower control arm set, part # FVD34391192set. Set is sold per axle. 2 necessary per car.
$152.90
Make a selection FVD34391192SET Replace worn-out original front lower control arm bushings with our FVD sport bushings, made of rubber with an 85 shore hardness value that is the same as the rs models. 85 shore is more durable, provides more positive suspension location and is still quiet and comfortable for street use. Features: better handling reduces that sloppy steering feel makes precision adjustments of the suspension easier does not produce any noise like the teflon bushings. Rubber has a shore hardness value of 85 (like rs models) fit's like oem, simple installation made in Germany set is sold per axle. 2 necessary per car.
$158.40
Make a selection FVD33150005 Restore proper suspension geometry with this adjustable lower rear control arm. The factory control arm cannot compensate enough when lowering your Porsche, leaving you with as much as ½ inch of toe in. The result is poor handling and rapid tire wear. This kit will provide the additional adjustment needed. The adjusting link has a left and right hand thread on each end. Rotating the link will increase or decrease the overall length of the arm. A precision teflon lined spherical rod end replaces the compliant rubber factory bushing for improved suspension response and feedback, and also reduces toe changes during acceleration and deceleration. Sold in pairs. 1 necessary per car.
$764.50
Make a selection TSPOR002 Torque solution dogbone rear control arms General Fitment911 1998-05
$682.76
Make a selection
$11.26
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |